Bgp Wait-On-End-Of-Rib - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

bgp wait-on-end-of-rib

bgp wait-on-end-of-rib seconds
Syntax
no bgp wait-on-end-of-rib
Command introduced in JUNOSe Release 8.2.0.
Release Information
Specifies how long BGP waits to receive an End-of-RIB marker sent by route-target
Description
address family peers to signal the peer has finished advertising route-target
membership information. Applies to all peers in the route-target address family. The
no version restores the default value.
Options
Address Family Configuration, Router Configuration
Mode
seconds Number of seconds BGP wait for End-of-RIB marker, in the range
1–3600; default is 60 seconds
Chapter 3: B Commands
299
bgp wait-on-end-of-rib