Boot Revert-Tolerance - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

boot revert-tolerance

boot revert-tolerance count time
Syntax
no boot revert-tolerance
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets the reversion tolerances that the boot logic uses to determine whether the router
Description
should use the normal or backup settings. Issuing this command when high availability
is enabled results in the system cold-restarting the router and using the backup
settings if the tolerance settings are met. The no version restores the default reversion
tolerance settings. The default settings are 3 crashes in 30 minutes.
Options
Global Configuration
Mode
count Number of times the operational SRP software crashes; in the range
0–4294967295; default value is 3
time Time in the range 0–4294967295 seconds in which the set number (count)
of crashes occurs; the default setting is 1800
Chapter 3: B Commands
305
boot revert-tolerance