Baseline Bridge Interface - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

baseline bridge interface

baseline bridge interface interfaceType interfaceSpecifier
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets a statistics baseline for a specified network interface belonging to a bridge group
Description
or VPLS instance. The router implements the baseline by reading and storing the
statistics at the time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved. There is no no version.
NOTE: Using the baseline bridge interface command for a VPLS instance affects
the specified network interface associated with the VPLS instance, but has no effect
on the VPLS virtual core interface, which represents all of the MPLS tunnels from the
router to the remote VPLS edge (VE) devices. To set a statistics baseline for the VPLS
virtual core interface, use the baseline bridge interface vpls command.
Options
Privileged Exec
Mode
Related Topics
220
baseline bridge interface
interfaceType One of the following interface types listed in Interface Types and
Specifiers on page 5
atm
fastEthernet
gigabitEthernet
tenGigabitEthernet
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
Setting a Baseline for VPLS Statistics in the JUNOSe BGP and MPLS Configuration
Guide