Example: QoS Profile Attachment to Port
Copyright © 2010, Juniper Networks, Inc.
-------
---------
atm-default@atm
ip
atm-default@atm
atm-vc
atm-default@atm
Bridge
atm-default@atm
ipv6
atm-default@atm
ip
atm-default@atm
atm
atm-default@atm
atm-vc
atm-default@atm
Bridge
atm-default@atm
ipv6
In Figure 38 on page 135, the major ATM interface, 11/0, has QoS profile qp1 explicitly
attached. The major ATM interface has three ATM subinterfaces configured:
ATM 11/0.1—No QoS profile is explicitly attached
ATM 11/0.2—QoS profile qp2 is attached
ATM 11/0.3—No QoS profile is explicitly attached
The qp1 profile overrides the QoS port-type profile, atm-default, on subinterfaces 1 and
3. It does not override profile qp2, which was explicitly attached to subinterface 2.
Figure 38: Attaching QoS Profile to ATM Interface and Subinterface
To configure this example:
Create and configure QoS profile qp1.
1.
host1(config)#qos-profile qp-1
host1(config-qos-profile)#atm-vp node scheduler-profile sp1
host1(config-qos-profile)#atm-vc queue traffic-class tc1 scheduler-profile sp1
queue-profile qp1
host1(config-qos-profile)#atm-vc queue traffic-class tc2 scheduler-profile sp2
queue-profile qp2
host1(config-qos-profile)#atm-vc queue traffic-class tc3 scheduler-profile sp3
queue-profile qp3
host1(config-qos-profile)#atm-vc queue traffic-class tc4 scheduler-profile sp4
queue-profile qp4
host1(config-qos-profile)#atm-vc queue traffic-class tc5 scheduler-profile sp5
queue-profile qp5
host1(config-qos-profile)#exit
Create and configure QoS profile qp2.
2.
Chapter 16: Configuring and Attaching QoS Profiles to an Interface
----
-------
--------- ------- -------
node
default
node
default
node
default
node
default
queue best-effort
default
queue best-effort
default
queue best-effort
default
queue best-effort
default
queue best-effort
default
default
default
default
default
default
default
default
default
default
135