ADTRAN AOS Version R10.1.0 Command Reference Manual page 2076

Command Reference Guide
ip urlfilter <name>
Use the ip urlfilter command to apply a universal resource locator (URL) filter to the interface for all
inbound or outbound traffic. Use the no form of this command to remove the URL filter from an interface.
Variations of this command include:
ip urlfilter <name> in
ip urlfilter <name> out
Syntax Description
<name>
in
out
Default Values
By default, there are no URL filters applied to any interfaces.
Command History
Release 12.1
Release 14.1
Release 15.1
Functional Notes
The firewall must be enabled using the ip firewall command in order to use URL filters. The URL filter
must be created by using the ip urlfilter <name> http command before applying it to the interface. Refer
to ip urlfilter <name> http on page 1174
Usage Examples
The following example performs URL filtering on all traffic entering through BVI 1 and matches the URL
filter named MyFilter:
(config)#interface bvi 1
(config-bvi 1)#ip urlfilter MyFilter in
60000CRG0-35E
Specifies the URL filter name to use on the interface.
Applies the filter to the inbound traffic.
Applies the filter to the outbound traffic.
Command was introduced.
Command was expanded to include the virtual local area network (VLAN)
interfaces.
Command was expanded to include the bridged virtual interfaces (BVIs).
for more information on using this command.
Copyright © 2012 ADTRAN, Inc.
BVI Interface Command Set
2076