Table of Contents
Advertisement
Command Reference Guide
traffic-shape rate <value>
Use the traffic-shape rate command to specify and enforce an output bandwidth for the bridged virtual
interface (BVI). Use the no form of this command to disable this feature. Variations of this command
include:
traffic-shape rate <value>
traffic-shape rate <value> <burst>
Syntax Description
<value>
<burst>
Default Values
By default, traffic-shape rate is disabled.
Command History
Release 10.1
Release 15.1
Functional Notes
Traffic shaping can be used to limit the virtual local area network (VLAN) interface to a particular rate or to
specify use of quality of service (QoS).
Usage Examples
The following example sets the outbound rate of BVI 1 to 128 kbps and applies a QoS policy that gives all
Realtime Transport Protocol (RTP) traffic priority over all other traffic:
(config)#qos map voip 1
(config-qos-map)#match ip rtp 10000 10500 all
(config-qos-map)#priority unlimited
(config-qos-map)#interface bvi 1
(config-bvi 1)#traffic-shape rate 128000
(config-bvi 1)#qos-policy out voip
60000CRG0-35E
Specifies the rate (in bits per second) at which the interface should be shaped.
Optional. Specifies the allowed burst in bytes. By default, the burst is
specified as the rate divided by 5 and represents the number of bytes that
would flow within 200 ms.
Command was introduced.
Command was expanded to include the bridged virtual interfaces (BVIs).
Copyright © 2012 ADTRAN, Inc.
BVI Interface Command Set
2084
Advertisement
Table of Contents
