Demand Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
D I
EMAND NTERFACE
To create a virtual demand interface and/or activate the Demand Interface Configuration mode, enter the
interface demand command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface demand 1
(config-demand 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
bandwidth <value> on page 2090
called-number <number> on page 2091
caller-number <number> on page 2092
connect-mode on page 2093
connect-order on page 2094
connect-sequence on page 2095
connect-sequence attempts <value> on page 2097
connect-sequence interface-recovery on page 2098
crypto map <name> on page 2099
demand-hold-queue <number> timeout <value> on page 2101
dynamic-dns on page 2102
fair-queue on page 2104
fast-idle <value> on page 2105
hold-queue <value> out on page 2106
idle-timeout <value> on page 2107
ip commands begin on page 2108
ipv6 dhcp relay destination <ipv6 address> on page 2139
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 2140
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

Demand Interface Command Set

2086