Inarp - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
inarp
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
inarp [ frequency ]
no inarp
Command introduced in JunosE Release 7.1.0.
ATM VC Class Configuration mode added in JunosE Release 7.3.0.
In ATM VC Configuration mode, enables Inverse ARP (InARP) on an ATM PVC that resides
on an ATM 1483 NBMA subinterface. Optionally, you can specify the InARP refresh rate.
The inarp command is valid only for data PVCs configured with aal5snap encapsulation;
you cannot use this command for data PVCs with other encapsulation types or for control
(ILMI or signaling) PVCs. The no version restores the default behavior, which disables
InARP.
In ATM VC Class Configuration mode, enables InARP as part of a VC class definition that
you assign to an ATM data PVC. The no version restores the default behavior, which
disables InARP, in the VC class.
frequency—InARP refresh rate in minutes, in the range 1–60; default value is 15
ATM VC Configuration, ATM VC Class Configuration
Chapter 10: I Commands
703
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers