Ip Vrrp Icr-Partition Group - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

ip vrrp icr-partition group

Syntax
Release Information
Description
Options
Mode
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
ip vrrp vrid icr-partition group partitionGroupingType
Command introduced in JunosE Release 10.3.0.
Configures the ICR partition to use either S-VLAN-based grouping or VLAN-based grouping
for subscribers. If you specify VLAN as the grouping type or partition type, the ICR partition
consists of single-tagged VLAN-based subinterfaces. By default, the ICR partition uses
S-VLAN-based grouping. There is no no version.
vrid—VRID identifier; a number in the range 1–255
partitionGroupingType—One of the following partition types:
svlan—Configures the ICR partition to use double-tagged S-VLAN based
subinterfaces.
vlan—Configures the ICR partition to use single-tagged VLAN based subinterfaces.
Interface Configuration, Subinterface Configuration
Grouping ICR Subscribers Based on S-VLAN IDs
Grouping ICR Subscribers Based on VLAN IDs
Configuring an ICR Partition
Chapter 10: I Commands
973