Table of Contents
Advertisement
Command Reference Guide
connect-sequence attempts <value>
Use the connect-sequence attempts command to limit the number of times the connect sequence will
cycle when its entries are unable to establish a connection. When the maximum number of attempts are
exhausted, the interface will go into recovery mode. Refer to
2098
for more information. Use the no form of this command to restore the default value.
Syntax Description
<value>
Default Values
By default, the connect-sequence attempts are unlimited.
Command History
Release 11.1
Usage Examples
The following example instructs demand interface 1 to attempt its connection sequence 500 times:
(config)#interface demand 1
(config-demand 1)#connect-sequence attempts 500
60000CRG0-35E
Specifies the number of times the connect sequence will cycle through its
entries if it is unable to make a connection. Range is 0 to 65535.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Demand Interface Command Set
connect-sequence interface-recovery on page
2097
Advertisement
Table of Contents
