Configuring Infranet Controller Ip Address Pool Policies (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual

NSM Infranet Controller Configuration Guide

Configuring Infranet Controller IP Address Pool Policies (NSM Procedure)

98
You can configure a pool of virtual IP addresses that you want the Infranet Controller to
automatically assign to endpoints by creating IP address pool policies. You can associate
an IP address pool with one or more Infranet Enforcers.
To configure an IP address pool policy:
In the NSM navigation tree, select Device Manager> Devices.
1.
Click the Device Tree tab, and then double-click the Infranet Controller for which you
2.
want to configure an IP address pool policy.
Click the Configuration tab. In the configuration tree, select UAC > Infranet Enforcer
3.
> IP Address Pools.
Add or modify IP address pool policy settings as specified in Table 29 on page 98.
4.
Table 30 on page 99 gives the syntax for IP address pools.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 29: IP Address Pool Policy Configuration Details
Option
Name
Description
IP Address Pool
Function Your Action
Specifies the IP address Enter a name for the IP address pool
pool policy name. policy.
Describes the IP address Enter a brief description for the IP
pool policy. address pool policy.
Specifies IP addresses or Click the Add button and enter the IP
a range of IP addresses for address range as specified in Table 30
the Infranet Controller to on page 99, where the last component
assign to endpoints. of the IP address is a range delimited
by a hyphen (-). No special characters
are allowed.
For example, to allocate all addresses
in the range 172.20.0.0 through
172.20.3.255, enter 172.20.0.0-3.255.
To allocate all addresses in a class C
network, specify 10.20.30.0/24.
NOTE: Select the Infranet Enforcer(s)
to which you want to apply this IP
address pool policy from the
Non-members list and click Add to
move it to the Members list.
To apply the policy to all Infranet
Enforcers, do not add any Infranet
Enforcers and leave the default setting
(all).
Copyright © 2010, Juniper Networks, Inc.