Radius Ietf Attributes; Nas-Ip-Address; Nas-Port - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

RADIUS IETF Attributes

radius override nas-ip-addr tunnel-client-endpoint
radius override nas-info
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
This section describes the RADIUS IETF attributes that you can configure using CLI
commands. The attributes are listed numerically—each attribute is followed by a list of
the commands that you can use to manage the attribute and descriptions of each
command.

[4] NAS-IP-Address

Use the following commands to configure, manage, and display information for the
NAS-IP-Address RADIUS attribute.
radius override nas-ip-addr tunnel-client-endpoint
radius override nas-info
Use to configure the RADIUS client (LNS) to use the tunnel-client-endpoint (LAC) IP
address for the NAS-IP-Address attribute.
See radius override nas-ip-addr tunnel-client-endpoint
Example
host1(config)#radius override nas-ip-addr tunnel-client-endpoint
Use the no version to restore the default address.
Use in the correct virtual router context to override standard use of NAS-IP-Address
and NAS-Identifier attributes for AAA broadcast accounting; specifies that the attributes
for the authentication virtual router be included in accounting packets instead of the
attributes for the virtual router that generates the accounting information.
Example
host1(config)#virtual-router vrXyz1
host1:vrXyz1(config)#radius override nas-info
Use the no version to restore standard use of the NAS-IP-Address and NAS-Identifier
attributes.
See radius override nas-info
Monitoring Override Settings of RADIUS IETF Attributes on page 303

[5] NAS-Port

Use the following commands to manage and display information for the NAS-Port
RADIUS attribute:
radius include nas-port
radius nas-port-format
Chapter 3: Configuring RADIUS Attributes
189