Ip Auto-Detect Ip-Subscriber - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

ip auto-detect ip-subscriber

Syntax
Release Information
Description
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] ip auto-detect ip-subscriber
Command introduced before JunosE Release 7.1.0.
Sets the router's packet detect feature, specifying that IP automatically detect packets
that do not match any entries in the demultiplexer table. When an unmatched packet is
detected, an event is generated that determines whether to create a dynamic subscriber
interface or to configure an existing interface. The no version disables autodetection.
Interface Configuration, Profile Configuration
Chapter 10: I Commands
743