Configuring Subscriber Management For Ip Subscribers On Dynamic Bridged Ethernet Interfaces - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

Configuring Subscriber Management for IP Subscribers on Dynamic Bridged Ethernet Interfaces

Copyright © 2010, Juniper Networks, Inc.
Use to configure a local subscriber on the E Series router to support authentication
and configuration from RADIUS for a dynamic bridged Ethernet or IPoA interface.
For detailed information about how to use this command, see "subscriber" on page 553.
Example
host1(config-subif)#subscriber bridgedEthernet user-prefix charlie domain myisp
password-prefix lucy
Use the no version to remove the subscriber.
See subscriber.
You can use the JunosE subscriber management application to configure and manage
IP subscribers associated with a dynamic bridged Ethernet over static ATM 1483 interface
column, as described in "Authenticating Subscribers on Dynamic Bridged Ethernet over
Static ATM Interfaces" on page 519.
To use the subscriber management application to configure IP subscribers on a dynamic
bridged Ethernet interface for RADIUS authentication:
Define an IP service profile that contains the subscriber's RADIUS authentication
1.
parameters including the username, domain, and password.
Configure the interface profile from which the router creates a dynamic bridged
2.
Ethernet interface column.
a. Include the desired characteristics for the upper-layer encapsulation types.
b. (Optional) Specify the name of the route map used to configure the IP subscriber
interface.
c. Use the bridge1483 service-profile command to assign the specified IP service
profile to the interface profile. The IP service profile contains the RADIUS
authentication parameters for subscribers on the dynamic bridged Ethernet
interface.
Define the underlying static or dynamic ATM 1483 subinterface on which the dynamic
3.
bridged Ethernet interface column is built.
a. Assign the specified interface profile to the ATM 1483 subinterface.
b. Enable autodetection (autoconfiguration) of the bridged Ethernet upper-layer
encapsulation type.
c. Define the ATM PVC over which data is transmitted.
(Optional) Use the show profile command to verify assignment of the IP service
4.
profile to the interface profile.
For information, see "show profile" on page 604.
Chapter 17: Configuring Dynamic Interfaces
557