Table of Contents
Advertisement
Addressing With the AAU
For example:
R2 = W [ P4++P5 ] (Z) ;
loads a 16-bit word into the low half of the destination register
zero-extends it to 32 bits. The value of the pointer
the value of the pointer
For example:
R2 = [ I2++M1 ]
loads a 32-bit word into the destination register
register,
, is updated by the value in the Modify register,
I2
Addressing Circular Buffers
The DAGs support addressing circular buffers. Circular buffers are a range
of addresses containing data that the DAG steps through repeatedly,
wrapping around to repeat stepping through the same range of addresses
in a circular pattern.
The DAGs use four types of data address registers for addressing circular
buffers. For circular buffering, the registers operate this way:
• The Index (I) register contains the value that the DAG outputs on
the address bus.
• The Modify (M) register contains the post-modify amount (posi-
tive or negative) that the DAG adds to the I-register at the end of
each memory access.
Any M-register can be used with any I-register. The modify value
can also be an immediate value instead of an M-register. The size of
the modify value must be less than or equal to the length (L-regis-
ter) of the circular buffer.
5-12
ADSP-BF53x/BF56x Blackfin Processor Programming Reference
.
P5
;
R2
is incremented by
P4
. The value in the Index
R2
.
M1
and
Advertisement
Table of Contents
