Ip Auto-Configure Ip-Subscriber - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

ip auto-configure ip-subscriber

Syntax
Release Information
Description
Options
Mode
742
[ no ] ip auto-configure ip-subscriber [ include-primary | exclude-primary ]
Command introduced before JunosE Release 7.1.0.
include-primary and exclude-primary keywords added in JunosE Release 7.1.0.
Configures a primary IP interface to support creation of dynamic subscriber interfaces.
The include-primary and exclude-primary keywords specify whether the primary interface
can be assigned to a subscriber. The no version disables creation of dynamic subscriber
interfaces on this primary IP interface.
include-primary—Specifies that the primary interface can be assigned to a subscriber;
the no version disables the assignment of the primary interface
exclude-primary—Specifies that the primary interface cannot be assigned to a
subscriber; the no version enables the assignment of the primary interface
Interface Configuration, Profile Configuration, Subinterface Configuration
Copyright © 2010, Juniper Networks, Inc.