Gre-Tunnel Policy - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

Software for e series broadband services routers command reference a to m
Table of Contents

Advertisement

gre-tunnel policy

Syntax
Release Information
Description
Options
Mode
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
gre-tunnel policy { input | output } policyName
[ statistics { enabled | disabled | preserve } | merge ]
no gre-tunnel policy { input | output } [ policyName ]
Command introduced before JunosE Release 7.1.0.
merge keyword added in JunosE Release 7.2.0.
Assigns a GRE tunnel policy list to an interface. If you enter the gre-tunnel policy command
and the policy list does not exist, the router creates a policy list with no rules, the default.
Attaching this policy list to an interface filters all packets on that interface. You must
specify the input or output keyword to assign the policy list to the ingress or egress of
the interface. The no version removes the association between a policy list and an
interface.
input—Applies policy to data arriving at this interface
output—Applies policy to data leaving this interface
policyName—Name of the policy; a maximum of 40 characters
statistics—Enables or disables collection of policy routing statistics
enabled—Enables collection of policy routing statistics
disabled—Disables collection of policy routing statistics
preserve—Preserves existing statistics for any classifier-list that is the same for both
the new and old policy attachments when you attach a new policy to an interface
merge—Enables merging of multiple policies to form a single policy
Interface Configuration
Setting a Statistics Baseline for Policies
Chapter 8: G Commands
669

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents