Creating Or Modifying Classifier Control Lists For Gre Tunnel Policy Lists; Creating Or Modifying Classifier Control Lists For Ip Policy Lists; Creating Classifier Control List For Only Ip Policy Lists; Sources - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x Policy Management Configuration Guide
Related
Documentation

Creating or Modifying Classifier Control Lists for GRE Tunnel Policy Lists

Related
Documentation

Creating or Modifying Classifier Control Lists for IP Policy Lists

Creating Classifier Control List for Only IP Policy Lists

Setting Up an IP Classifier Control List to Accept Traffic from All Sources
10
host1(config)#frame-relay classifier-list frclassifier color red user-packet-class 10
de-bit 1
frame-relay classifier-list
You can create or modify a classifier control list that can be used only in GRE tunnel policy
lists.
Issue the gre-tunnel classifier-list command:
host1(config)#gre-tunnel classifier-list greClassifier50 color yellow user-packet-class
7 dsfield 40
gre-tunnel classifier-list
Tasks to create or modify classifier control lists for IP policy lists:
Creating Classifier Control List for Only IP Policy Lists on page 10
Setting Up an IP Classifier Control List to Accept Traffic from All Sources on page 10
Classifying IP Traffic Based on Source and Destination Addresses on page 11
Using IP Classifier Control Lists to Match Route Class Values on page 11
Creating IP Classifier Control Lists for TCP and UDP Ports on page 11
Creating an IP Classifier Control List That Matches the ToS Byte on page 12
Creating an IP Classifier Control List That Filters ICMP Echo Requests on page 12
Creating IP Classifier Control Lists That Use TCP or IP Flags on page 12
Creating IP Classifier Control Lists That Match the IP Fragmentation Offset on page 12
You can create or modify a classifier control list that can be used only in IP policy lists.The
behavior of multiple-element classifier-list classification is the logical OR of the elements
in the CLACL.
Issue the ip classifier-list command to match all packets that have a source IP address
of 192.168.30.100 or have a destination IP address of 192.168.30.200:
host1(config)#ip classifier-list boston5 ip host 192.168.30.100 any
host1(config)#ip classifier-list boston5 ip any host 192.168.30.200
You can set up a CLACL to accept IP traffic from all source addresses on the subnet.
Issue the ip classifier-list command:
Copyright © 2010, Juniper Networks, Inc.