Atm Vp-Tunnel - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

atm vp-tunnel

atm vp-tunnel vpi { cbr kbps | kbps }
Syntax
no atm vp-tunnel vpi
Command introduced before JUNOSe Release 7.1.0.
Release Information
Defines a virtual path tunnel and configures the rate of traffic flow within the tunnel.
Description
For QoS configurations, use to configure a shapeless VP tunnel. The no version
removes the restriction.
Options
Interface Configuration
Mode
vpi Number in the range 0–255; virtual path identifier of this PVC
cbr Specifies the service class as constant bit rate
kbps Tunnel rate for a virtual path. The tunnel rate can be a value in the range
0–4294967295, when you specify the rate of traffic flow without the constant
bit rate (CBR) service category, and can be a value in the range 1–4294967295,
when you specify the rate of traffic flow with the CBR service class. Because the
CBR service category guarantees a fixed amount of bandwidth to be allotted to
the client, an error message is displayed if you configure a value of 0 for the
tunnel rate for CBR traffic flows. The aggregate to this traffic from all circuits
configured in the tunnel is held to the specified rate. Certain line modules may
have minimum rates for VP tunnels. Using a rate of 0 configures a shapeless
tunnel (a tunnel with no rate) that is used for VP shaping in the SAR.
Chapter 2: A Commands
193
atm vp-tunnel