ST STM32L4+ Series Reference Manual page 430

Chrom-ART Accelerator controller (DMA2D)
•
Memory transfer: PL bits of DMA2D_NLR = 0
•
Memory transfer: MODE bits of DMA2D_CR are invalid
13.3.13 DMA2D transfer control (start, suspend, abort and completion)
Once the DMA2D is configured, the transfer can be launched by setting the START bit of the
DMA2D_CR register. Once the transfer is completed, the START bit is automatically reset
and the TCIF flag of the DMA2D_ISR register is raised. An interrupt can be generated if the
TCIE bit of the DMA2D_CR is set.
The user application can suspend the DMA2D at any time by setting the SUSP bit of the
DMA2D_CR register. The transaction can then be aborted by setting the ABORT bit of the
DMA2D_CR register or can be restarted by resetting the SUSP bit of the DMA2D_CR
register.
The user application can abort at any time an ongoing transaction by setting the ABORT bit
of the DMA2D_CR register. In this case, the TCIF flag is not raised.
Automatic CLUT transfers can also be aborted or suspended by using the ABORT or the
SUSP bit of the DMA2D_CR register.
13.3.14 Watermark
A watermark can be programmed to generate an interrupt when the last pixel of a given line
has been written to the destination memory area.
The line number is defined in the LW[15:0] field of the DMA2D_LWR register.
When the last pixel of this line has been transferred, the TWIF flag of the DMA2D_ISR
register is raised and an interrupt is generated if the TWIE bit of the DMA2D_CR is set.
13.3.15 Error management
Two kind of errors can be triggered:
•
AHB master port errors signaled by the TEIF flag of the DMA2D_ISR register.
• Conflicts caused by CLUT access (CPU trying to access the CLUT while a CLUT
loading or a DMA2D transfer is ongoing) signalled by the CAEIF flag of the
DMA2D_ISR register.
Both flags are associated to their own interrupt enable flag in the DMA2D_CR register to
generate an interrupt if need be (TEIE and CAEIE).
13.3.16 AHB dead time
To limit the AHB bandwidth usage, a dead time between two consecutive AHB accesses
can be programmed.
This feature can be enabled by setting the EN bit in the DMA2D_AMTCR register.
The dead time value is stored in the DT[7:0] field of the DMA2D_AMTCR register. This
value represents the guaranteed minimum number of cycles between two consecutive
transactions on the AHB bus.
The update of the dead time value while the DMA2D is running is taken into account for the
next AHB transfer.
430/2301 RM0432 Rev 6
RM0432