ST STM32L4+ Series Reference Manual page 380

Direct memory access controller (DMA)
Pointer incrementation
The peripheral and memory pointers may be automatically incremented after each transfer,
depending on the PINC and MINC bits of the DMA_CCRx register.
If the incremented mode is enabled (PINC or MINC set to 1), the address of the next
transfer is the address of the previous one incremented by 1, 2 or 4, depending on the data
size defined in PSIZE[1:0] or MSIZE[1:0]. The first transfer address is the one programmed
in the DMA_CPARx or DMA_CMARx register. During transfers, these registers keep the
initially programmed value. The current transfer addresses (in the current internal
peripheral/memory address register) are not accessible by software.
If the channel x is configured in non-circular mode, no DMA request is served after the last
data transfer (once the number of single data to transfer reaches zero). The DMA channel
must be disabled in order to reload a new number of data items into the DMA_CNDTRx
register.
Note: If the channel x is disabled, the DMA registers are not reset. The DMA channel registers
(DMA_CCRx, DMA_CPARx and DMA_CMARx) retain the initial values programmed during
the channel configuration phase.
In circular mode, after the last data transfer, the DMA_CNDTRx register is automatically
reloaded with the initially programmed value. The current internal address registers are
reloaded with the base address values from the DMA_CPARx and DMA_CMARx registers.
Channel configuration procedure
The following sequence is needed to configure a DMA channel x:
1. Set the peripheral register address in the DMA_CPARx register.
The data is moved from/to this address to/from the memory after the peripheral event,
or after the channel is enabled in memory-to-memory mode.
2. Set the memory address in the DMA_CMARx register.
The data is written to/read from the memory after the peripheral event or after the
channel is enabled in memory-to-memory mode.
3. Configure the total number of data to transfer in the DMA_CNDTRx register.
After each data transfer, this value is decremented.
4. Configure the parameters listed below in the DMA_CCRx register:
–
–
–
–
–
–
5. Activate the channel by setting the EN bit in the DMA_CCRx register.
A channel, as soon as enabled, may serve any DMA request from the peripheral connected
to this channel, or may start a memory-to-memory block transfer.
Note: The two last steps of the channel configuration procedure may be merged into a single
access to the DMA_CCRx register, to configure and enable the channel.
380/2301
the channel priority
the data transfer direction
the circular mode
the peripheral and memory incremented mode
the peripheral and memory data size
the interrupt enable at half and/or full transfer and/or transfer error
RM0432 Rev 6
RM0432