Pim Ipv6 Timer Join-Prune; Pim Ipv6 Triggered-Hello-Delay - H3C MSR 20-20 Command Reference Manual

1492 C 93: IP 6 PIM C
HAPTER V
Description
Related command:
Example

pim ipv6 timer join-prune

Syntax
View
Parameter
Description
Related command:
Example

pim ipv6 triggered-hello-delay

Syntax
View
C
ONFIGURATION OMMANDS
Use the pim ipv6 timer hello
the interval at which hello messages are sent.
Use the
undo pim ipv6 timer hello
By default, hello messages are sent at the interval of 30 seconds.
timer hello (IPv6 PIM view).
# Set the hello interval to 40 seconds on Ethernet 1/0.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] pim ipv6 timer hello 40
pim ipv6 timer join-prune interval
undo pim ipv6 timer join-prune
Interface view
interval: Join/prune interval in seconds, with an effective range of 1 to
2,147,483,647.
Use the
pim ipv6 timer join-prune
interface the interval at which join/prune messages are sent.
Use the undo pim ipv6 timer join-prune
setting.
By default, the join/prune interval is 60 seconds.
timer join-prune (IPv6 PIM view).
# Set the join/prune interval to 80 seconds on Ethernet 1/0.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] pim ipv6 timer join-prune 80
pim ipv6 triggered-hello-delay interval
undo pim ipv6 trigged-hello-delay
Interface view
command to configure on the current interface
command to restore the default setting.
command to configure on the current
command to restore the default