H3C MSR 20-20 Command Reference Manual page 1308

1308 C 84: IP 6 OSPF
HAPTER V
Description
Examples
3 C C
V ONFIGURATION OMMANDS
dead seconds: Specifies the neighbor dead time in seconds, ranging from 1 to
32768, with the default as 40. This value must equal to the dead seconds
configured on the virtual link peer router, and at least four times the value of hello
seconds.
instance Instance-id: The instance ID of an virtual link, in the range of 0 to 255,
with the default as 0.
Use the
vlink-peer
Use the undo vlink-peer
For a non-backbone area without direct connection with the backbone area or for
a backbone area that cannot maintain connectivity, you can use the vlink-peer
command to create logical connectivity. A virtual link can be considered as an
interface with OSPFv3 enabled, because parameters such as hello, dead,
retransmit and trans-delay are configured in the similar way.
Both ends of a virtual link are ABRs that are configured with the vlink-peer
command.
# Create a virtual link to 10.110.0.3.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] area 10.0.0.0
[Sysname-ospfv3-1-area-10.0.0.0] vlink-peer 10.110.0.3
command to create and configure a virtual link.
command to remove a virtual link.