Debugging Bgp All - H3C MSR 20-20 Command Reference Manual

73

debugging bgp all

Syntax
View
Default Level
Parameters
Description
Examples
BGP D
EBUGGING
debugging bgp [ ipv4-address | ipv6-address ] all
undo debugging bgp [ ipv4-address | ipv6-address] all
User view
1: Monitor level
ipv4-address: IPv4 address of a peer.
ipv6-address: IPv6 address of a peer.
Use the debugging bgp all
Use the
undo debugging bgp all
By default, all BGP debugging is disabled.
Note the following:
This command enables all BGP debugging, which may cause heavy traffic and
■
affect system performance; therefore, use this command only when necessary.
Disable debugging once the debugging operation is complete.
■
# Enable all BGP debugging while Device A and Device B are establishing an IBGP
peer relationship with each other.
[Sysname-bgp]display this
#
bgp 100
undo synchronization
peer 10.1.1.2 as-number 100
#
=======================
[Sysname-bgp] display this
#
bgp 100
undo synchronization
peer 10.1.1.1 as-number 100
#
C
OMMANDS
command to enable all BGP debugging.
command to disable all BGP debugging.