Isis Enable; Isis Mesh-Group - H3C MSR 20-20 Command Reference Manual

isis enable

Syntax
View
Parameters
Description
Related commands:
Examples

isis mesh-group

Syntax
View
Parameters
Description
isis enable [ process-id ]
undo isis enable
Interface view
process-id: Specifies a IS-IS process ID, ranging from 1 to 65535. The default is 1.
Use the command to enable an IS-IS routing process on the interface.
isis enable
Use the undo isis enable
No IS-IS routing process is enabled on an interface by default.
To run IS-IS, you need to use the isis command to enable an IS-IS process, and use
the network-entity command to configure a network entity title (NET) for the
router, and then use the isis enable command to enable IS-IS on each interface
that needs to run the IS-IS process.
isis, network-entity.
# Create IS-IS routing process 1, and enable it on the Serial2/0 interface.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] network-entity 10.0001.1010.1020.1030.00
[Sysname-isis-1] quit
[Sysname] interface serial2/0
[Sysname-serial2/0] isis enable 1
isis mesh-group { mesh-group-number | mesh-blocked }
undo isis mesh-group
Interface view
mesh-group-number: Specifies a mesh group number from 1 to 4294967295.
mesh-blocked: Blocks the interface from flooding LSPs to make it send LSPs only
after receiving requests.
Use the
isis mesh-group
group.
Use the
undo isis mesh-group
group.
command to disable this configuration.
command to add the interface into a specified mesh
command to delete the interface from a mesh
1067