Display Mpls Te Tunnel Path - H3C MSR 20-20 Command Reference Manual

1596 C 96: MPLS TE C
HAPTER

display mpls te tunnel path

Syntax
View
Parameter
Description
Example
C
ONFIGURATION OMMANDS
Table 414 Description on the fields of the display mpls te tunnel verbose command
Field
No
LSP-Id
Tunnel-Name
Destination
In-Interface
Out-Interface
Tunnel BW
Class Type
Ingress LSR-Id
Setup-Priority
Hold-Priority
Sign-Protocol
Resv Style
IncludeAnyAff
ExcludeAllAff
IncludeAllAff
Created Time
display mpls te tunnel path [ tunnel-name tunnel-name ] [ lsp-id lsr-id lsp-id ]
Any view
tunnel-name tunnel-name: Tunnel name, a string of 1 to 63 characters.
lsr-id: Ingress LSR ID, in dotted decimal notation.
lsp-id: LSP ID, in the range 1 to 65535.
Use the
display mpls te tunnel path
that the specified or all MPLS TE tunnels traverse on this node.
# Display the paths that all MPLS TE tunnels traverse.
<Sysname> display mpls te tunnel path
Tunnel Interface Name Tunnel0:
Lsp ID : 1.1.1.9:10
Hop information:
Hop 0: 192.1.1.1;
Hop 1: 12.1.1.2;
Hop 2: 10.202.2.2.
Description
Number
LSP ID of tunnel
Tunnel name configured on the ingress node
Destination router ID
Incoming interface
Outgoing interface
Tunnel bandwidth
Service class type
Ingress LSR ID
Setup priority of link
Holding priority of link
Signaling protocol
Reservation style
Any affinity properties that must be included
Link properties that are excluded
All link affinity properties that must be included
Time when the tunnel was created
command to display the path or paths