Timer Hello (Pim View); Timer Join-Prune (Pim View) - H3C MSR 20-20 Command Reference Manual

1428 C 90: PIM C
HAPTER
Related command:
Example

timer hello (PIM view)

Syntax
View
Parameter
Description
Related command:
Example

timer join-prune (PIM view)

Syntax
View
Parameter
Description
C
ONFIGURATION OMMANDS
You can configure up to 50 static RPs on the same device.
■
display pim rp-info and auto-rp enable.
# In the public instance, configure the interface with the IP address 11.110.0.6 to
be a static RP that serves the multicast groups defined in ACL 2001, and give
priority to this static RP in the case of static/dynamic RP conflict.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] static-rp 11.110.0.6 2001 preferred
timer hello interval
undo timer hello
Public instance PIM view, VPN instance PIM view
interval: Hello interval in seconds, with an effective range of 1 to 2,147,483,647.
Use the
timer hello
Use the undo timer hello
By default, hello messages are sent at the interval of 30 seconds.
pim timer hello.
# Set the global hello interval to 40 seconds in the public instance.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] timer hello 40
timer join-prune interval
undo timer join-prune
Public instance PIM view, VPN instance PIM view
interval: Join/prune interval in seconds, with an effective range of 1 to
2,147,483,647.
Use the
timer join-prune
command to configure the hello interval globally.
command to restore the default setting.
command to configure the join/prune interval globally.