Primary Authorization; Reset Hwtacacs Statistics - H3C MSR 20-20 Command Reference Manual

1982 C 129: HWTACACS C
HAPTER

primary authorization

Syntax
View
Parameter
Description
Related command:
Example

reset hwtacacs statistics

Syntax
View
Parameter
C
ONFIGURATION OMMANDS
primary authorization ip-address [ port-number ]
undo primary authorization
HWTACACS scheme view
ip-address: IP address of the server, a valid unicast address in dotted decimal
notation. The default is 0.0.0.0.
port-number: Port number of the server. It ranges from 1 to 65535 and defaults to
49.
Use the
primary authorization
authorization server.
Use the
undo primary authorization
Note that:
The IP addresses of the primary and secondary authorization servers cannot be
■
the same. Otherwise, the configuration fails.
The HWTACACS service port configured on the device and that of the
■
HWTACACS server must be consistent.
If you configure the command for more than one time, the last configuration
■
takes effect.
You can remove an authorization server only when no active TCP connection
■
for sending authorization packets is using it.
display hwtacacs.
# Configure the primary authorization server.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] primary authorization 10.163.155.13 49
reset hwtacacs statistics { accounting | all | authentication | authorization }
User view
accounting: Clears HWTACACS accounting statistics.
all: Clears all HWTACACS statistics.
command to specify the primary HWTACACS
command to remove the configuration.