Display Tunnel-Policy - H3C MSR 20-20 Command Reference Manual

display tunnel-policy

Syntax
View
Parameter
Description
Related command:
Example
Table 459 Description on the fields of the display ospf sham-link command
Field
RouterId
Source-IP
Destination-IP
State
Cost
# Display information about OSPF sham links in area 1.
<Sysname> display ospf sham-link area 1
OSPF Process 100 with Router ID 100.1.1.2
Sham-Link: 3.3.3.3 --> 5.5.5.5
Neighbour State: Full
Area: 0.0.0.1
Cost: 10 State: P-2-P, Type: Sham
Timers: Hello 10 , Dead 40 , Retransmit 5 , Transmit Delay 1
Table 460 Description on the fields of the display ospf sham-link area command
Field Description
Sham-Link Sham link expressed in the format of source IP address to destination
IP address
Neighbor State Status of the sham link neighbor
Area Destination IP address of the sham link
Cost Cost of the sham link
State Status of the sham link
Type Type of the sham link
Timers Timers of the sham link
display tunnel-policy { all | policy-name tunnel-policy-name }
Any view
all: Specifies all tunneling policies.
tunnel-policy-name: Name of a tunneling policy, a string of 1 to 19 characters.
Use the
display tunnel-policy
tunneling policy or all tunneling policies.
tunnel-policy, tunnel select-seq load-balance-number.
# Display all tunneling policies.
<Sysname>display tunnel-policy all
Tunnel Policy Name
------------------------------------------------------
Description
Router ID of the sham link
Source IP address of the sham link
Destination IP address of the sham link
Status of the sham link interface
Cost of the sham link
command to display information about a
Select-Seq Load balance No
1691