Mld Timer Other-Querier-Present - H3C MSR 20-20 Command Reference Manual

1454 C 92: MLD C
HAPTER
Example

mld timer other-querier-present

Syntax
View
Parameter
Description
Related command:
Example
C
ONFIGURATION OMMANDS
If the IPv6 multicast address is in the SSM multicast address range, and if an IPv6
address is specified for the multicast source, multicast messages carrying the (S,G)
entry, namely, the source IPv6 address information, can be sent out of this
interface.
# Configure Ethernet 1/0 to be a statically-connected member of the multicast
group FF03::101.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] mld static-group ff03::101
# Configure Ethernet 1/0 to forward multicast data of the multicast source
2001::101 to the multicast group FF04::202.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] mld static-group ff04::202 source 2001::101
mld timer other-querier-present interval
undo mld timer other-querier-present
Interface view
interval: MLD other querier present interval in seconds, in the range of 60 to 300.
Use the
mld timer other-querier-present
other querier present interval on the current interface.
Use the
undo mld timer other-querier-present
system default.
By default, the MLD other querier present interval is determined by the following
formula:
MLD other querier present interval = [ MLD query interval ] times [ MLD querier
robustness variable ] plus [ maximum response delay for MLD general queries ]
divided by two.
n
By default, the values of the three parameters in the above-mentioned formula are
125, 2, and 10, respectively, so the default MLD other querier present interval is
125 x 2 + 10 / 2 = 255 (seconds).
timer other-querier-present (MLD view), mld timer query, mld
robust-count, mld max-response-time, and display mld interface.
# Set the MLD other querier present interval to 200 seconds on Ethernet 1/0.
command to configure the MLD
command to restore the