Mld Enable - H3C MSR 20-20 Command Reference Manual

1448 C 92: MLD C
HAPTER
Example
mld
Syntax
View
Parameter
Description
Related command:
Example

mld enable

Syntax
View
Parameter
Description
C
ONFIGURATION OMMANDS
# Globally set the maximum response delay for general queries to 8 seconds.
<Sysname> system-view
[Sysname] mld
[Sysname-mld] max-response-time 8
mld
undo mld
System view
None
Use the command to enter MLD view.
mld
Use the
undo mld
This command can take effect only after IPv6 multicast routing is enabled on the
device.
mld enable, and multicast ipv6 routing-enable on page 1440.
# Enter MLD view.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] mld
[Sysname-mld]
mld enable
undo mld enable
Interface view
None
Use the mld enable
Use the
undo mld enable
By default, MLD is disabled on the current interface.
Note that:
command to remove the configurations done in MLD view.
command to enable MLD on the current interface.
command to disable MLD on the current interface.