Primary Authentication (Radius Scheme View) - H3C MSR 20-20 Command Reference Manual

Msr 20/30/50 series routers
Hide thumbs Also See for MSR 20-20:
Table of Contents

Advertisement

Related command:
Example

primary authentication (RADIUS scheme view)

Syntax
View
Parameter
Description
Use the
undo primary accounting
By default, the default IP address is 0.0.0.0, and the default port number 1813.
Note that:
The IP addresses of the primary and secondary accounting servers cannot be
the same. Otherwise, the configuration fails.
The RADIUS service port configured on the device and that of the RADIUS
server must be consistent.
key (RADIUS scheme view), radius scheme, state.
# Set the IP address of the primary accounting server for RADIUS scheme radius1
to 10.110.1.2 and the UDP port of the server to 1813.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] primary accounting 10.110.1.2 1813
primary authentication ip-address [ port-number ]
undo primary authentication
RADIUS scheme view
ip-address: IP address of the primary authentication/authorization server.
port-number: UDP port number of the primary authentication/authorization
server, which ranges from 1 to 65535.
Use the
primary authentication
port of the primary RADIUS authentication/authorization server.
Use the
undo primary authentication
By default, the default IP address is 0.0.0.0, and the default port number 1812.
Note that:
After creating a RADIUS scheme, you are supposed to configure the IP address
and UDP port of each RADIUS server (primary/secondary
authentication/authorization or accounting server). The configuration of
RADIUS servers is at your discretion except that there must be at least one
authentication/authorization server and one accounting server. Besides, ensure
that the RADIUS service port settings on the device are consistent with the port
settings on the RADIUS servers.
The IP addresses of the primary and secondary authentication/authorization
servers cannot be the same. Otherwise, the configuration fails.
command to restore the defaults.
command to configure the IP address and UDP
command to restore the defaults.
1959

Advertisement

Table of Contents
loading

This manual is also suitable for:

Msr 20-21Msr 30-16Msr 30-20Msr 30-40Msr 30-60Msr 50 ... Show all

Table of Contents