Abr-Summary (Ospf Area View) - H3C MSR 20-20 Command Reference Manual

76

abr-summary (OSPF area view)

Syntax
View
Parameters
Description
OSPF C
n
Refer to "MPLS TE Configuration Commands" on page 1565 for OSPF TE
■
related commands.
Refer to "MPLS L2VPN Configuration Commands" on page 1645 and "MPLS
■
L3VPN Configuration Commands" on page 1671.
abr-summary ip-address { mask | mask-length } [ advertise | not-advertise ] [ cost
cost ]
undo abr-summary ip-address { mask | mask-length }
OSPF area view
ip-address: IP address of the summary route, in dotted decimal format.
mask: Mask of the IP address in dotted decimal format.
mask-length: Mask length, in the range 0 to 32 bits.
advertise | not-advertise: Advertises or not to advertise the summary route. By
default, the summary route is advertised.
cost cost: Specifies the cost of the summary route, in the range 1 to 16777215.
The default cost is to the biggest cost value among routes that are summarized.
Use the
abr-summary
Border Router.
Use the
undo abr-summary
By default, no route summarization is available on an ABR.
This command is applicable to ABRs only and is used for route summarization in
an area. Multiple contiguous networks may be available in an area, where you can
summarize them with one network on the ABR for advertisement. The ABR
advertises only the summary route to other areas.
With the undo abr-summary command used, summarized routes will be
advertised.
ONFIGURATION
command to configure a summary route on the Area
command to remove a summary route.
C
OMMANDS