Pim Timer Hello - H3C S3600 Series Command Manual

Command Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510
View
VLAN interface view
Parameter
None
Description
Use the pim sm command to enable the PIM-SM protocol.
Use the undo pim sm command to disable the PIM-SM protocol.
By default, the PIM-SM protocol is disabled on the switch.
You must enable the PIM-SM protocol on each VLAN interface respectively. Generally,
the PIM-SM protocol is enabled on each VLAN interface.
Related command: multicast routing-enable.
Example
# Enable the PIM-SM protocol on VLAN-interface10.
<H3C>system-view
System View: return to User View with Ctrl+Z.
[H3C] multicast routing-enable
[H3C] interface Vlan-interface 10
[H3C-Vlan-interface10] pim sm

6.1.16 pim timer hello

Syntax
pim timer hello seconds
undo pim timer hello
View
VLAN interface view
Parameter
seconds: Interval (in seconds) at which a VLAN interface sends Hello packets, in the
range of 1 to 18,000.
Description
Use the pim timer hello command to set the interval at which a VLAN interface sends
Hello packets.
Use the undo pim timer hello command to restore the default value of the interval.
By default, a VLAN interface sends Hello packets at the interval of 30 seconds.
Chapter 6 PIM Configuration Commands
6-15