Vlink-Peer (Ospf Area View) - H3C MSR 20-20 Command Reference Manual

1159
Examples # Enable a stub-router.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] stub-router

vlink-peer (OSPF area view)

Syntax
vlink-peer router-id [ hello seconds | retransmit seconds | trans-delay seconds | dead
seconds | simple [ plain | cipher ] password | { md5 | hmac-md5 } key-id [ plain |
cipher ] password ]*
undo vlink-peer router-id [ hello | retransmit | trans-delay | dead | [ simple | { md5 |
hmac-md5 } key-id ] ]*
View OSPF area view
Parameters router-id: ID of the neighbor router on the virtual link.
hello seconds: Hello interval in seconds, in the range 1 to 8192, which defaults to
10 and is identical to the value on its virtual link neighbor.
retransmit seconds: Retransmit interval in seconds, in the range 1 to 3600, which
defaults to 5.
trans-delay seconds: Transmit delay interval in seconds, in the range 1 to 3600,
which defaults to 1.
dead seconds: Dead interval in seconds, in the range 1 to 32768, which defaults
to 40 and is identical to the value on its virtual link neighbor. The dead interval is at
least four times the hello interval.
md5: MD5 authentication.
hmac-md5: HMAC-MD5 authentication.
simple: Simple authentication.
key-id: Key ID for MD5 or HMAC-MD5 authentication, in the range 1 to 255.
plain | cipher: Plain or cipher type. If plain is specified, only plain password is
supported and displayed upon displaying the configuration file. If cipher is
specified, both plain and cipher are supported, but only cipher password is
displayed when displaying the configuration file. By default, MD5 and
HMAC-MD5 support cipher password, and simple authentication supports plain
password.
password: Password of plain or cipher. Simple authentication: For plain type, a
plain password is a string of up to 8 characters. For cipher type, a plain password is
a string of up to 8 characters, and a cipher password is a string of up to 24
characters. MD5/HMAC-MD5 authentication: For plain type, a plain password is a
string of up to 16 characters. For cipher type, a plain password is a string of up to
16 characters, and a cipher password is a string of up to 24 characters.