Fr Ipv6 Ind Solicitation Retrans-Timer - H3C MSR810 Command Reference Manual

Views
Interface view
Predefined user roles
network-admin
Parameters
seconds: Specifies the IND request interval in the range of 10 to 120 seconds.
Usage guidelines
This command takes effect only when IND is enabled.
Examples
# Set the type of the Frame Relay interface Serial 2/1/0 to DTE, and set the IND request interval to 15
seconds for Serial 2/1/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] link-protocol fr
[Sysname-Serial2/1/0] fr interface-type dte
[Sysname-Serial2/1/0] ipv6 ind holdtime 15

fr ipv6 ind solicitation retrans-timer

Use fr ipv6 ind solicitation retrans-timer to set the interval between IND requests that are sent
continuously.
Use undo fr ipv6 ind solicitation retrans-timer to restore the default.
Syntax
fr ipv6 ind solicitation retrans-timer seconds
undo fr ipv6 ind solicitation retrans-timer
Default
The interval between IND requests that are sent continuously is 1 second.
Views
Interface view
Predefined user roles
network-admin
Parameters
seconds: Specifies the interval between IND requests that are sent continuously, in the range of 1 to
5 seconds.
Usage guidelines
An interface that fails to receive IND responses within the IND request interval continuously sends
IND requests up to three times at the interval set by using this command.
Examples
# Set the type of the Frame Relay interface Serial 2/1/0 to DTE, and s et the interval between
continuous IND requests to 2 seconds for Serial 2/1/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] link-protocol fr
349