Multicast Ipv6 Longest-Match; Multicast Ipv6 Minimum-Hoplimit - H3C MSR 20-20 Command Reference Manual

Description
Example

multicast ipv6 longest-match

Syntax
View
Parameter
Description
Example

multicast ipv6 minimum-hoplimit

Syntax
View
Parameter
source-group: Specifies to implement IPv6 multicast load splitting on a per-source
and per-group basis.
Use the
multicast load-splitting
multicast traffic.
Use the
undo multicast load-splitting
IPv6 multicast traffic.
By default, load splitting of IPv6 multicast traffic is disabled.
# Enable load splitting of IPv6 multicast traffic on a per-source basis.
<Sysname> system-view
[Sysname] multicast ipv6 load-splitting source
multicast ipv6 longest-match
undo multicast ipv6 longest-match
System view
None
Use the
multicast ipv6 longest-match
based on the longest match, namely based on the prefix length.
Use the undo multicast ipv6 longest-match
configuration of route selection based on the longest match.
By default, routes are selected in order of routing entries.
# Configure route selection based on the longest match.
<Sysname> system-view
[Sysname] multicast ipv6 longest-match
multicast ipv6 minimum-hoplimit ttl-value
undo multicast ipv6 minimum-hoplimit
Interface view
hoplimit-value: Minimum hop limit required for an IPv6 multicast packet to be
forwarded on the interface, in the range of 1 to 255.
command to enable load splitting of IPv6
command to disable load splitting of
command to configure route selection
command to remove the
1439