State-Refresh-Hoplimit; State-Refresh-Interval (Ipv6 Pim View) - H3C MSR 20-20 Command Reference Manual

Example

state-refresh-hoplimit

Syntax
View
Parameter
Description
Related command:
Example

state-refresh-interval (IPv6 PIM view)

Syntax
View
By default, the IPv6 SSM group range is FF3x::/32, where x represents any legal
scope.
This command allows you to define an address range of permitted or denied IPv6
multicast sources or IPv6 multicast groups. If the match succeeds, the running
multicast mode will be IPv6 PIM-SSM; otherwise the multicast mode will be IPv6
PIM-SM.
# Configure FF3E:0:8192::/96 as the IPv6 SSM group range.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
[Sysname-acl6-basic-2000] rule permit source ff3e:0:8192:: 96
[Sysname-acl6-basic-2000] quit
[Sysname] pim ipv6
[Sysname-pim6] ssm-policy 2000
state-refresh-hoplimit hoplimit-value
undo state-refresh-hoplimit
IPv6 PIM view
hoplimit-value: Hop limit value of state refresh messages, in the range of 1 to 255.
Use the state-refresh-hoplimit
state refresh messages.
Use the
undo state-refresh-hoplimit
By default, the hop limit value of state refresh messages is 255.
pim ipv6 state-refresh-capable, state-refresh-interval (IPv6 PIM view), and
state-refresh-rate-limit (IPv6 PIM view).
# Set the hop limit value of state refresh messages to 45.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] state-refresh-hoplimit 45
state-refresh-interval interval
undo state-refresh-interval
IPv6 PIM view
command to configure the hop limit value of
command to restore the system default.
1499