Display Isis Route Ipv6 - H3C MSR 20-20 Command Reference Manual

83

display isis route ipv6

Syntax
View
Parameters
Description
Examples
IP 6 IS-IS C
V
C
OMMANDS
n
IPv6 IS-IS supports all the features of IPv4 IS-IS except that it advertises IPv6 routing
information instead. This document describes only IPv6 IS-IS exclusive commands.
Refer to "IS-IS Configuration Commands" on page 1037 for other IS-IS
configuration commands.
display isis route ipv6 [ [ level-1 | level-2 ] | verbose ]* [ process-id ]
Any view
verbose: Displays detailed IPv6 IS-IS routing information.
process-id: IS-IS process ID, in the range 1 to 65535.
level-1: Display Level-1 IPv6 IS-IS routes only.
level-2: Displays Level-2 IPv6 IS-IS routes only.
n
If no level is specified, both Level-1 and Level-2 (namely Level-1-2) routing
information will be displayed.
Use the display isis route ipv6
information.
# Display IPv6 IS-IS routing information.
<Sysname> display isis route ipv6
Destination: 2001:1::
Flag : R/L/-
Next Hop : FE80::200:5EFF:FE64:8905
Destination: 2001:2::
Flag : D/L/-
Next Hop : Direct
Flags: D-Direct, R-Added to RM, L-Advertised in LSPs, U-Up/Down Bit Set
Destination: 2001:1::
Flag : -/-/-
Destination: 2001:2::
Flag : D/L/-
ONFIGURATION
command to display IPv6 IS-IS routing
Route information for ISIS(1)
-----------------------------
ISIS(1) IPv6 Level-1 Forwarding Table
-------------------------------------
ISIS(1) IPv6 Level-2 Forwarding Table
-------------------------------------
PrefixLen: 64
Cost : 20
Interface: Eth0/1/0
PrefixLen: 64
Cost : 10
Interface: Eth0/1/0
PrefixLen: 64
Cost : 20
PrefixLen: 64
Cost : 10