Validate-Source-Address; Version - H3C MSR 20-20 Command Reference Manual

validate-source-address

Syntax
View
Parameters
Description
Examples

version

Syntax
View
Parameters
Description
validate-source-address
undo validate-source-address
RIP view
None
Use the
validate-source-address
validation on incoming RIP routing updates.
Use the undo validate-source-address
address validation.
The source IP address validation is enabled by default.
Generally, disabling the validation is not recommended.
# Enable the source IP address validation on incoming messages.
<Sysname> system-view
[Sysname-rip] rip 100
[Sysname-rip-100] validate-source-address
version { 1 | 2 }
undo version
RIP view
1: Specifies the RIP version as RIP-1.
2: Specifies the RIP version as RIP-2. RIP-2 messages are multicast.
Use the command to specify a global RIP version.
version
Use the
undo version
By default, the global RIP version is RIP-1.
Note that:
If an interface has an RIP version specified, the RIP version takes precedence
■
over the global one.
command to enable the source IP address
command to disable the source IP
command to remove the configured global RIP version.
1185