Display Traffic Behavior - H3C MSR 20-20 Command Reference Manual

1792 C 109: D
HAPTER EFINING
Description
Related commands:
Examples

display traffic behavior

Syntax
View
Parameters
Description
Examples
T B C
RAFFIC EHAVIOR OMMANDS
Use the car command to configure traffic monitoring for a traffic behavior.
Use the command to delete the configuration of traffic monitoring.
undo car
The policy can be used in the input or outbound direction of the interface.
Application of policy including of TP policy on an interface will cause the previous
qos car command ineffective.
If this command is frequently configured on classes of the same policy, the last
configuration will overwrite the previous ones.
qos policy, traffic behavior, classifier behavior.
# Use traffic monitor for a behavior. The normal traffic of packets is 200 kbps.
Burst traffic twice of the normal traffic can pass initially and later the traffic is
transmitted normally when the rate does not exceed 200 kbps. When the rate
exceeds 200 kbps, the IP precedence of the packet turns to 0 and the packet is
transmitted.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] car cir 200 cbs 50000 ebs 0 green pass r
ed remark-prec-pass 0
display traffic behavior { system-defined | user-defined } [ behavior-name ]
Any view
system-defined: Behavior pre-defined by the system.
user-defined: Behavior pre-defined by the user.
behavior-name: Behavior name. If it is not specified, the information of the
behaviors pre-defined by the system or by the user will be displayed.
Use the
display traffic behavior
traffic behavior configured on the router.
# Display information about user-defined traffic behavior.
<Sysname> display traffic behavior user-defined
User Defined Behavior Information:
Behavior: test
Assured Forwarding:
Bandwidth 30 (Kbps)
Discard Method: Tail
Queue Length
General Traffic Shape:
CIR 300 (kbps), CBS 15000 (byte), EBS 0 (byte)
command to display the information of the
: 64 (Packets)