Jp-Pkt-Size (Ipv6 Pim View); Jp-Queue-Size (Ipv6 Pim View) - H3C MSR 20-20 Command Reference Manual

jp-pkt-size (IPv6 PIM view)

Syntax
View
Parameter
Description
Related command:
Example

jp-queue-size (IPv6 PIM view)

Syntax
View
Parameter
Description
jp-pkt-size packet-size
undo jp-pkt-size
IPv6 PIM view
packet-size: Maximum size of join/prune messages in bytes, with an effective
range of 100 to 64000.
Use the command to configure the maximum size of join/prune
jp-pkt-size
messages.
Use the undo jp-pkt-size
By default, the maximum size of join/prune messages is 8,100 bytes.
jp-queue-size (IPv6 PIM view).
# Set the maximum size of join/prune messages to 1,500 bytes.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] jp-pkt-size 1500
jp-queue-size queue-size
undo jp-queue-size
IPv6 PIM view
queue-size: Maximum number of (S, G) entries in a join/prune message, in the
range of 1 to 4,096.
Use the jp-queue-size
entries in a join/prune message.
Use the
undo jp-queue-size
By default, a join/prune messages contains a maximum of 1,020 (S, G) entries.
When you use this command, take the following into account:
The size of the forwarding table. In a network that does not support packet
■
fragmentation, if you configure a large queue-size, a join/prune message may
contain a large number of groups, causing the message length to exceed the
command to restore the default setting.
command to configure the maximum number of (S, G)
command to restore the default setting.
1483