Rip Mib-Binding; Rip Output - H3C MSR 20-20 Command Reference Manual

Examples

rip mib-binding

Syntax
View
Parameters
Description
Examples

rip output

Syntax
View
Parameters
Description
# Configure an additional metric of 12 for RIP routes sent on Ethernet1/0.
<Sysname> system-view
[Sysname] interface ethernet1/0
[Sysname-Ethernet1/0] rip metricout 12
rip mib-binding process-id
undo rip mib-binding
System view
process-id: RIP process number, in the range of 1 to 65535.
Use the
rip mib-binding
process.
Use the undo rip mib-binding
By default, MIB operations are bound to the RIP process with the smallest process
ID.
# Configure RIP 100 to accept SNMP requests.
<Sysname> system-view
[Sysname] rip mib-binding 100
# Restore the default.
[Sysname] undo rip mib-binding
rip output
undo rip output
Interface view
None
Use the command to enable the interface to send RIP messages.
rip output
Use the undo rip output
messages.
Sending RIP messages is enabled on an interface by default.
command to bind MIB operations with a specified RIP
command to restore the default.
command to disable the interface from sending RIP
1177