Mpls Te Bandwidth; Mpls Te Bandwidth Change Thresholds - H3C MSR 20-20 Command Reference Manual

Example

mpls te bandwidth

Syntax
View
Parameter
Description
Example

mpls te bandwidth change thresholds

Syntax
View
# Tunnel 0 provides protection for LSPs using BC0 bandwidth without protecting
bandwidth. Tunnel 1 provides protection for LSPs using BC1 bandwidth and it can
protect 1000 kbps bandwidth.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te backup bandwidth bc0 un-limited
[Sysname-Tunnel0] quit
[Sysname] interface tunnel 1
[Sysname-Tunnel1] mpls te backup bandwidth bc1 1000
mpls te bandwidth [ bc0 | bc1 ] bandwidth
undo mpls te bandwidth
Tunnel interface view
bc0: Obtains bandwidth from BC0.
bc1: Obtains bandwidth from BC1.
bandwidth: Bandwidth needed by the MPLS TE tunnel, in the range 1 to
32000000 kbps.
Use the
mpls te bandwidth
tunnel.
Use the undo mpls te bandwidth
By default, no bandwidth is assigned to MPLS TE tunnels.
If neither the bc1 keyword nor the bc0 keyword is specified, bandwidth is
assigned using the global bandwidth pool (BC0).
# Assign 1000 kbps bandwidth to MPLS TE tunnel 0.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te bandwidth 1000
mpls te bandwidth change thresholds { down | up } percent
undo mpls te bandwidth change thresholds { down | up }
Interface view
command to assign bandwidth to the MPLS TE
command to restore the default.
1619