Static-Cr-Lsp Transit - H3C MSR 20-20 Command Reference Manual

Description
Example

static-cr-lsp transit

Syntax
View
Parameter
Description
Use the
static-cr-lsp ingress
ingress node.
Use the
undo static-cr-lsp ingress
n
The next hop address cannot be a local public address when configuring the static
CR-LSP on the ingress or a transit node.
# Configure a static CR-LSP on the ingress node, setting its name to Tunnel3,
destination IP address to 202.25.38.1, destination address mask length to 24, next
hop IP address to 202.55.25.33, outgoing label to 237, and required bandwidth
to 20 kbps.
<Sysname> system-view
[Sysname] static-cr-lsp ingress Tunnel3 destination 202.25.38.1 next
hop 202.55.25.33 out-label 237 bandwidth 20
static-cr-lsp transit tunnel-name incoming-interface interface-type interface-number
in-label in-label-value { nexthop next-hop-addr | outgoing-interface interface-type
interface-number } out-label out-label-value [ bandwidth [ bc0 | bc1 ]
bandwidth-value ]
undo static-cr-lsp transit tunnel-name
System view
Tunnel-name: Tunnel name comprising 1 to 15 characters.
next-hop-addr: Next hop address.
outgoing-interface interface-type interface-number: Specifies an outgoing
interface for the static CR-LSP.
in-label-value: Incoming label, in the range 16 to 1023.
out-label-value: Outgoing label, in the range 16 to 1023.
bc0: Obtains bandwidth from a subpool.
bc1: Obtains bandwidth from the global pool.
bandwidth-value: Bandwidth assigned to the CR-LSP, in the range 1 to 32000000
kbps.
Use the static-cr-lsp transit
node.
Use the
undo static-cr-lsp transit
command to configure a static CR-LSP at the
command to remove the static CR-LSP.
command to configure a static CR-LSP on a transit
command to remove the static CR-LSP.
1641