Example
mpls te
Syntax
View
Parameter
Description
Example
# Enable RSVP message retransmission on interface Ethernet 1/0, setting the
increment value delta to 2 and the initial retransmission interval to 1000
milliseconds.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] mpls rsvp-te timer retransmission increment-va
lue 2 retransmit-value 1000
mpls te
undo mpls te
MPLS view, interface view
None
Use the
mpls te
Use the
undo mpls te
By default, MPLS TE is disabled.
When performed in MPLS view, the mpls te command enables MPLS TE globally
and its undo form disables MPLS TE and removes all CR-LSPs.
When performed in interface view, the mpls te command enables MPLS TE on an
interface and its undo form disables MPLS TE and removes all CR-LSPs on the
interface.
Before you can enable MPLS TE on an interface, enable MPLS TE globally first.
c
CAUTION: After changing the MTU of an interface where MPLS TE is enabled,
you need to perform the shutdown command and then the undo shutdown
command to refresh the TE tunnels on it.
# Enable MPLS TE globally in MPLS view.
<Sysname> system-view
[Sysname] mpls lsr-id 1.1.1.9
[Sysname] mpls
[Sysname-mpls] mpls te
# Enable MPLS TE on interface Ethernet 1/0.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] mpls
[Sysname-Ethernet1/0] mpls te
command to enable MPLS TE.
command to disable MPLS TE.
1615