Ospfv3 Cost; Ospfv3 Dr-Priority - H3C MSR 20-20 Command Reference Manual

1300 C 84: IP 6 OSPF
HAPTER V
Description
Examples

ospfv3 cost

Syntax
View
Parameters
Description
Examples

ospfv3 dr-priority

Syntax
View
3 C C
V ONFIGURATION OMMANDS
Use the ospfv3 area
specify the area for the process.
Use the
undo ospfv3 area
OSPFv3 is not enabled on an interface by default.
# Enable OSPFv3 process 1 on an interface that belongs to instance 1 and specify
area 1 for the process.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-serial2/0] ospfv3 1 area 1 instance 1
ospfv3 cost value [ instance instance-id ]
undo ospfv3 cost [ instance instance-id ]
Interface view
value: OSPFv3 cost of the interface, in the range 1 to 65535.
instance-id: The instance ID of an interface, in the range of 0 to 255, which
defaults to 0.
Use the
ospfv3 cost
an instance.
Use the
undo ospfv3 cost
interface of an instance.
By default, a router's interface automatically calculates the OSPFv3 cost based on
its bandwidth.
# Specifies the OSPFv3 cost as 33 on an interface of instance 1.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] ospfv3 cost 33 instance 1
ospfv3 dr-priority priority [ instance instance-id ]
undo ospfv3 dr-priority [ instance instance-id ]
Interface view
command to enable an OSPFv3 process on the interface and
command to disable an OSPFv3 process.
command to configure the OSPFv3 cost on an interface of
command to restore the default OSPFv3 cost on an