Ip Ipv6-Prefix - H3C MSR 20-20 Command Reference Manual

ip ipv6-prefix

Syntax
View
Parameters
Description
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match ipv6 next-hop prefix-list p1
ip ipv6-prefix ipv6-prefix-name [ index index-number ] { deny | permit }
ipv6-address prefix-length [ greater-equal min-prefix-length ] [ less-equal
max-prefix-length ]
undo ip ipv6-prefix ipv6-prefix-name [ index index-number ]
System view
ipv6-prefix-name: IPv6 prefix list name, a string of 1 to 19 characters, for uniquely
specifying an IPv6 prefix list.
index-number: Index number, in the range 1 to 65535, for uniquely specifying an
IPv6 prefix list item. The item with a smaller index-number will be tested first.
permit: Specifies the matching mode for the IPv6 prefix list as permit, that is, if a
route matches the IPv6 prefix list, it passes the IPv6 prefix list without needing to
enter the next item for test. If not, it will enter the next item test.
deny: Specifies the matching mode for the IPv6 prefix list as deny, that is, if a
route matches the IPv6 prefix list, the route neither passes the filter nor enters the
next node for test. If not, the route will enter the next item test.
ipv6-address prefix-length: Specifies an IPv6 prefix and prefix length, with
prefix-length being in the range 0 to 128. When specified as :: 0, it matches the
default route.
greater-equal min-prefix-length: Greater than or equal to the minimum prefix
length.
less-equal max-prefix-length: Less than or equal to the maximum prefix length.
The length relation is mask-length <= min-mask-length <= max-mask-length <=
32. If only min-prefix-length is specified, the prefix length range is
[ min-prefix-length, 128 ]. If only max-prefix-length is specified, the prefix length
range is [ prefix-length, max-prefix-length ]. If both min-prefix-length and
max-prefix-length are specified, the prefix length range is [ min-prefix-length,
max-prefix-length ].
Use the
ip ipv6-prefix
Use the undo ip ipv6-prefix
No IPv6 prefix list is configured by default.
command to configure an IPv6 prefix list item.
command to remove an IPv6 prefix list or an item.
1215