Lsa-Generation-Interval; Lsdb-Overflow-Limit - H3C MSR 20-20 Command Reference Manual

lsa-generation-interval

Syntax
View
Parameters
Description
Related commands:
Examples

lsdb-overflow-limit

Syntax
View
Parameters
lsa-generation-interval maximum-interval [ initial-interval [ incremental-interval ] ]
undo lsa-generation-interval
OSPF view
maximum-interval: Maximum LSA generation interval in seconds, in the range 1 to
60.
initial-interval: Minimum LSA generation interval in milliseconds, in the range 10
to 60000. The default is 0 millisecond.
incremental-interval: LSA generation incremental interval in milliseconds, in the
range 10 to 60000, which defaults to 5000 milliseconds.
Use the
lsa-generation-interval
generation interval.
Use the undo lsa-generation-interval
The LSA generation interval defaults to 5 seconds.
With this command configured, when network changes are not frequent, an LSA
is generated at the initial-interval. If network changes become frequent, LSA
generation interval is incremented by a specified value each time a generation
happens, up to the maximum-interval.
lsa-arrival-interval.
# Configure the LSA generation maximum interval as 2 seconds, minimum interval
as 100 milliseconds and incremental interval as 100 milliseconds.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] lsa-generation-interval 2 100 100
lsdb-overflow-limit number
undo lsdb-overflow-limit
OSPF view
number: Specifies the upper limit of external LSAs in the LSDB, in the range 1 to
1000000.
command to configure the OSPF LSA
command to restore the default.
1139