Register-Suppression-Timeout (Ipv6 Pim View) - H3C MSR 20-20 Command Reference Manual

1494 C 93: IP 6 PIM C
HAPTER V
Parameter
Description
Related command:
Example

register-suppression-timeout (IPv6 PIM view)

Syntax
View
Parameter
Description
Related command:
Example
C
ONFIGURATION OMMANDS
acl6-number: Advanced IPv6 ACL number, in the range of 3000 to 3999. Only
register messages that match the permit statement of the IPv6 ACL can be
accepted by the RP.
Use the register-policy
messages.
Use the
undo register-policy
filtering rule.
By default, no register filtering rule is configured.
register-suppression-timeout (IPv6 PIM view).
# Configure a register filtering policy on the RP so that only IPv6 multicast sources
on the subnet 3:1::/64 can send IPv6 multicast data to the IPv6 multicast groups
on the subnet FF0E:13::/64.
<Sysname> system-view
[Sysname] acl ipv6 number 3000
[Sysname-acl6-adv-3000] rule permit ipv6 source 3:1:: 64 destination
ff0e:13:: 64
[Sysname-acl6-adv-3000] quit
[Sysname] pim ipv6
[Sysname-pim6] register-policy 3000
register-suppression-timeout interval
undo register-suppression-timeout
IPv6 PIM view
interval: Register suppression timeout in seconds, in the range of 1 to 3,600.
Use the
register-suppression-timeout
suppression timeout time.
Use the
undo register-suppression-timeout
setting.
By default, the register suppression timeout time is 60 seconds.
probe-interval (IPv6 PIM view) and register-policy (IPv6 PIM view).
# Set the register suppression timeout time to 70 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] register-suppression-timeout 70
command to configure an IPv6 ACL rule to filter register
command to remove the configured register
command to configure the register
command to restore the default